Smart-Plug, Smart-Lighting Energy Measurement Processor
![]()
- Parameters
- Features
- Description
| Part number |
SY7T609+S1 |
| User MPU core |
None |
| Signal processing core |
EMP |
| Supply voltage (V) |
3.3 |
| Total sensor inputs |
2 |
| Internal Flash(KBytes) |
8 |
| Internal RAM(KBytes) |
1.5 |
| Interface |
SPI, UART |
| Temp Sensor |
On-Chip |
| Oscillator |
On-Chip |
| Package |
TSSOP-14 |
| Note |
Single Phase |
- High resolution delta-sigma ADC with two analog (sensor) inputs
- Precision internal voltage and timing references minimize external components
- 24-bit energy measurement processor with nonvolatile storage of calibration and configuration data
- Flexible SPI or UART interface options with user configurable DIO
- Small 14-pin TSSOP package
The SY7T609+S1 is an energy measurement processor (EMP) designed for monitoring any 2-wire circuit. With an integrated oscillator and small profile, it is ideally suited for BOM optimized applications such as smart-plugs, smart appliances, lighting and building automation. SPI and UART interface options are supported. An optimized protocol for low baud rate UART communications further reduces the BOM cost when data isolation is required. The analog front end (AFE) provides differential analog inputs for interfacing to current sensors and voltage sensors. Scaled voltages from the sensors are fed to a high-resolution delta-sigma converter. A low power 24-bit energy measurement processor (EMP) with embedded firmware performs all the necessary computation, compensation, and data formatting for interfacing to any host controller. With available nonvolatile memory for storing calibration coefficients and configuration data, the SY7T609+S1 provides an autonomous solution that greatly simplifies system integration.
